temperature reduction
英 [ˈtemprətʃə(r) rɪˈdʌkʃn]
美 [ˈtemprətʃər rɪˈdʌkʃn]
网络 温度还原
英英释义
noun
双语例句
- The results showed that the temperature reduction coating had high emissivity, high reflectivity and make the temperature dropped 4~ 8 degree; the phase change coating had both function of good temperature self-adaptive and better thermal camouflage and IR fusion effect with the background.
结果表明，降温涂层具有高发射率、高反射率和4~8℃的降温效果；相变涂层具有优良的温度自适应功能，并在短时间内可实现对热源的伪装效果及与背景的融合性。 - Comparison with the common exterior wall green coating, market-available green coating and military green coating, a temperature reduction performance of home-made green solar heat reflective coating were studied.
与普通外墙用绿色涂料、市售绿色涂料和军用绿色涂料进行比较，研究了自制的绿色太阳热反射涂料的降温性能。 - That is because of increase of heat loss associated with the increase of air supply, besides the reduction of particles in the flame is another reason for the temperature reduction.
这一方面由于增加的空气带走了大量的热量，同时，火焰中烟灰颗粒浓度的不足，会引起所测火焰温度的降低。 - Based on the material of iron in some iron and steel companies, the low temperature reduction degradation of iron ore in the condition of injecting blends of coal and waste plastic in BF is studied.
以国内某钢铁公司的炼铁原料为基础，进行了高炉喷吹煤与废塑料条件下的矿石低温还原粉化性能研究。 - Research on the temperature reduction performance of green solar heat reflective coatings
绿色太阳热反射涂料降温性能研究 - Therefore, this thesis not only discussed about temperature reduction by water sprinkling, but also analyzed the control method for humidity inside the mine pit. 7.
所以本文在探讨降温洒水量的同时，也分析了井巷湿度控制的方法。 - This thesis discussed about calculation method of water sprinkling quantity and analyzing method of temperature reduction effects, and suggested control measures for high humidity.
本文探讨了洒水降温作业的洒水量解算方法和降温效果分析方法，并针对湿度过高的问题提出控制措施。 - A Discussion on Analytical Method of the Characteristics of Temperature Reduction by Air Condition System in Cab
机车司机室空调系统降温特性分析方法探讨 - The problems existed and results achieved during the trial-production were summarized. Some aspects such as temperature reduction, splashing, air-oxygen ratio and treatment efficiency in the course of operation have been initially studied.
总结了试生产中存在的问题和取得的结果，对工艺操作中的温降、喷溅、气氧比和处理效率等问题作了初步探讨。 - The constant volumetric delivery and melt temperature reduction bring a significant improvement in the quality of the end product.
稳定的体积流量和降低熔体温度对于改善最终产品的质量有重要意义。